Which next-hop router redundancy protocol provides backup for an assigned real IP address? A. HSRP B. GLBP C. VRRP D. CGMP Explanation: Using VRRP, the shared address of the next-hop router redundancy group can be the real address of a router interface. Virtual Router Redundancy Protocol (VRRP) is defined in RFC 2338. VRRP enables a […]

What command displays detailed information about the GLBP groups to which the switch belongs? A. switch# show standby B. switch# show glbp state C. switch# show glbp D. switch# show standby detail Explanation: The command show glbp displays detailed information about GLBP groups on the switch. This information includes the GLBP groups the switch is […]

What command can be used on a Cisco switch to display the virtual MAC address for the HSRP groups of which the switch is a member? A. switch# show standby mac B. switch# show hsrp mac C. switch# show standby D. switch# show standby brief Explanation: The command show standby can be used to display […]

Your network consists of one HSRP group of six routers. All of the routers are functioning properly. The network has been stable for several days. In which HSRP state are most of the routers? A. Learn B. Listen C. Standby D. Active Explanation: If all of the routers in the Hot Standby Routing Protocol (HSRP) […]

Which of the following features does GLBP provide, but not HSRP and VRRP? (Choose all that apply.) A. Support for single active router B. Support for automatic load balancing C. Support for multiple gateways D. Support for interface tracking Explanation: Support for automatic load balancing and support for multiple gateways are two features that are […]

What command would provide the output displayed in the exhibit? (Click on the Exhibit(s) button.) A. switch# show hsrp B. switch# show standby C. switch# show interface vlan D. switch# show standby brief Explanation: The command show standby brief displays the output in the exhibit. It is used to display a summary of the HSRP […]

Refer to the following exhibit: You have configured the routers in the diagram for HSRP, resulting in the displayed configurations. Which of the following routers were configured with the default HSRP values for each command? A. rtrA B. rtrB C. rtrC D. rtrD Explanation: Only rtrB has the default HSRP settings. The default values for […]

Which load-balancing algorithm does GLBP use by default? A. Random load-balancing B. Weighted load-balancing C. Round-robin load-balancing D. Host-dependent load-balancing Explanation: Round-robin load-balancing is the default load-balancing method used by Gateway Load Balancing Protocol (GLBP). The active virtual gateway (AVG) can be configured to use one of three load-balancing algorithms when selecting which active virtual […]

Which of the following statements best describes the result of issuing the command standby 44 timers 3 1 on an HSRP router? A. The holdtime will be set to a value of 3, and the hellotime will be set to a value of 1. B. The status of the standby router will be displayed as […]

Which statement best describes the function of Hot Standby Router Protocol (HSRP)? A. HSRP specifies a single IP address that all routers in the group must use. B. HSRP defines a set of routers that represent one virtual, fault-tolerant router. C. HSRP provides a round-robin gateway selection process to increase fault tolerance. D. HSRP defines […]