Examine the diagram below:

You attempt to make a Telnet connection from PC1 to the switch connected to the Web server, but the connection fails. After making a console connection to the
switch connected to the Web server and executing the show run command, you see the following information:
<output omitted>
interface vlan 1
ip address 58.59.6.2 255.0.0.0
!
ip default gateway 192.168.5.1
!
line vty 04
password ajax
login
Which value is NOT correct?

On a Cisco 2950 switch, which status LED and color combination indicates a Power On Self Test (POST) failure?

You have a class C address range and are planning a network that has an average of 50 hosts per subnet.
How many host bits will have to be borrowed for subnetting so that the maximum number of subnets can be implemented?

In the following partial output of the show ip route command, what does the letter D stand for?
D 192.1.2.0/24 via 5.1.1.71 [w:0 m:0]
C 192.8.1.1/32 directly connected to loopback 0

Which command is used to disable Cisco Discovery Protocol (CDP) on a Cisco router?

Which statements are TRUE regarding Internet Protocol version 6 (IPv6) addresses? (Choose three.)

You are the network administrator for your company. You want to use both IPv6 and IPv4 applications in the network. You also want to ensure that routers can route
both IPv6 and IPv4 packets.
Which deployment model should be implemented to accomplish the task?

You are configuring the link between a Cisco 2950 series switch and a Cisco 2611 router. You have physically connected the router’s Ethernet port to the switch
using a straight-through cable. The switch has not been configured, except for a hostname. The router’s hostname has also been configured, and the Ethernet port
has been enabled. However, you forgot to assign an IP address to the Ethernet port.
You issue the show cdp neighbors command and get the following output:

If you did not configure IP addresses, how is this information being passed between the two devices?

Which of the following features is used with the ip nat inside command to translate multiple devices in the internal network to the single address in the IP address
pool?

Which Cisco IOS command is used on a Catalyst 2950 series switch to verify the port security configuration of a switch port?