Which command would be used to establish static transla…
Which command would be used to establish static translation between an inside local address 192.168.144.25 and an inside global address 202.56.63.102?
Which of the following is NOT a VLAN Trunking Protocol …
Which of the following is NOT a VLAN Trunking Protocol (VTP) mode of operation?
Which Cisco IOS command can be used to troubleshoot swi…
Which Cisco IOS command can be used to troubleshoot switch startup problems on a Cisco Catalyst 2950 switch?
Click and drag the components on the left to their corresponding layers…
Which of the following values will be used by a router …
Which of the following values will be used by a router to make a routing decision when two routes have been learned from OSPF?
Which of the following statements are true?
Examine the following partial output of the show interfaces command.
Router# show interfaces ethernet 0/0
Ethernet0/0 is administratively down, line protocol is down
Hardware is AmdP2, address is 0003.e39b.9220 (bia 0003.e39b.9220)
Internet address is 10.1.0.254/16
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
<<output omitted>>
Which of the following statements are true? (Choose all that apply.)
What command was used to generate the output shown below?
What command was used to generate the output shown below?
Connection-specific DNS Suffix . : ajax.acme.com
Description . . . . .. . .: Broadcom NetXtreme 57xx Gigabit Controller
Physical Address. . . . . . . . : 00-1A-A0-E1-95-AB
DHCP Enabled. . . . . . . . . . : Yes
Autoconfiguration Enabled . . . : Yes
Link-local IPv6 Address . : fe80::ada3:8b73:a66e:6bc0%10(Preferred)
IPv4 Address. . . . . . . . . . : 10.88.2.177(Preferred)
Subnet Mask . . . . . . . . . . : 255.255.255.0
Lease Obtained. . . . . .. : Wednesday, October 05, 2011 4:31:32 PM
Lease Expires . . . . . . . : Friday, October 07, 2011 4:33:32 AM
Default Gateway . . . . . . . . : 10.88.2.6
DHCP Server . . . . . . . . . . : 10.88.10.48
DHCPv6 IAID . . . . . . . . . . : 234887840
DHCPv6 Client DUID. . . : 00-01-00-01-14-EE-0F-98-00-1A-A0-E1-95-AB
DNS Servers . . . . . . . . . . . : 10.88.10.48
10.75.139.18
NetBIOS over Tcpip. . . . . . . . : Enabled
Which of the following commands could be used to preven…
The conference room has a switch port available for use by the presenter during classes. You would liketo prevent that port from hosting a hub or switch. Which of
the following commands could be used to prevent that port from hosting a hub or switch?
what could be causing this problem?
You have successfully configured a router, but it prompts you to run Setup mode every time the router is restarted. Based on the following output, what could be
causing this problem?
RouterA# show version
Cisco Internetwork Operating System SoftwareIOS ™ 2500 Software (C2500-JS-L), Version 11.3(6), RELEASE SOFTWARE (fc1)
Copyright 1986-1998 by Cisco Systems, Inc.
Compiled Tue 06-Oct-98 22:17 by kpma
Image text-base: 0x03048CF4, data-base: 0x00001000
ROM: System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE
BOOTFLASH: 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(8a), RELEASE SOFTWARE (fc1)
RouterA uptime is 25 minutes
System restarted by power-on
System image file is “flash:c2500-js-l_113-6.bin”, booted via flash
Cisco 2500 (68030) processor (revision D) with 4096K/2048K bytes of memory.
Processor board ID 04203139, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
2Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read ONLY)
Configuration register is 0x2142
Which feature enables a host to obtain an IP address fr…
Which feature enables a host to obtain an IP address from a DHCP server on another subnet?