Which of the following NAT terms refers to a registered address that represents an inside host to an outside
network?

In the network exhibit, the routers are running OSPF and are set to the default configurations. (Click the Exhibit
(s) button.)

What would be the effect of configuring a loopback interface on RouterA with an address of 192.168.1.50/24?

When the copy running-config startup-config command is issued on a router, where is the configuration saved?

You are the network administrator for your company. You have a Class B address range and are planning for a
network that allows 150 hosts per subnet and at least 164 subnets.
Which subnet mask should you use to accomplish the task?

Which of the following commands would instruct OSPF to advertise ONLY the 192.168.10.0/24 network in Area
0?

A user in your network is having trouble accessing resources and the Internet. You decide to examine the
partial output of the ipconfig/all command on his machine. The output is shown below:

Which of the following statements describes the user’s problem?

Which Cisco IOS command is used to configure encapsulation for a PPP serial link on a Cisco router?

A router is running a classful routing protocol. Which command will enable this router to select a default route
when routing to an unknown subnet of a network for which it knows the major network?

Which type of Category 5 unshielded twisted-pair (UTP) cable is used to work as a trunk between two
switches?

Which of the following commands is used to verify the link-local, global unicast, and multicast addresses of an
IPv6 router?