You instructed your assistant to add a new router to the network. The routers in your network run OSPF. The
existing router, OldRouter, is configured as follows:
router ospf 1
network 192.168.5.0 0.0.0.255 area 0
network 192.168.10.0 0.0.0.255 area 0
The OldRouter interface that connects to NewRouter is 192.168.5.3/24. Your assistant shows you the
configuration that will be implemented:
newrouter(config)# router ospf 1
newrouter(config-router)# network 192.168.5.0 255.255.255.0 area 0
What is wrong with this configuration?

Which command is used to disable Cisco Discovery Protocol (CDP) on a Cisco router?

Which command would be used to establish static translation between an inside local address and an inside
global address?

You wish to configure Secure Shell (SSH) support on your router so that incoming VTY connections are
secure.
Which of the following commands must be configured? (Choose all that apply.)

Which Cisco IOS command is used on a Catalyst 2950 series switch to verify the port security configuration of
a switch port?

Assume that all ports on Layer 2 devices are in the same Virtual LAN (VLAN). View the given network topology.
(Click the Exhibit(s) button.)

Which network device should be placed at the highlighted box to produce a total of two broadcast domains and
seven collision domains in the network?

You are purchasing a device to upgrade your network. You need to determine the type of device required, as
well as the number and type of required interfaces. The device will host three LAN subnets and a T1 Internet
connection.
Which of the following device and interface combinations will support this requirement without providing any
unnecessary interfaces or using subinterfaces?

Which of the following statements are TRUE regarding the following output? (Choose all that apply.)

You are the network administrator for your company. The Chief Technical Officer of the company is looking for
a routing solution that satisfies the following requirements:
No routing protocol advertisements
Increased network security
No routing protocol overhead
Not concerned about fault tolerance
Which of the following routing techniques matches the criteria?

Which Cisco Internetwork Operating System (IOS) command is used to view the VLAN Trunking Protocol
(VTP) statistics information?