You are the network administrator for your company. Your company has opened a new site in London. The
Chief Technical Officer (CTO) of the company wants to implement a routing protocol that can provide the
following features:
Supports multiple large networks
Does not require a hierarchical physical topology
Supports VLSM
Provides loop prevention and fast convergence
Provides load balancing over un-equal cost links
Which routing protocol should be implemented in the new site?

You receive the following error message after addressing and enabling an interface:
%192.168.16.0 overlaps with FastEthernet0/0
Which two are NOT the causes of the error message? (Choose two.)

Which of the following are characteristics of Enhanced Interior Gateway Routing Protocol (EIGRP)? (Choose all
that apply.)

Refer to the following configuration on a Cisco router to allow Telnet access to remote users:
Router(config)#line vty 0 2
Router(config-line)#login
Router(config-line)#password guest
How many users can Telnet into this router at the same time?

Which Cisco Internetwork Operating System (IOS) command can be used to configure the location of the
configuration file?

Which prompt indicates the configuration mode at which Cisco IOS debug commands can be issued?

You are the Cisco administrator for Metroil. One of your assistants has submitted the given diagram as a
potential addressing plan for two offices. Both offices use EIGRP as the routing protocol. You immediately see
a problem with the proposal.
Which of the following actions could be a solution? (Choose two. Each correct option is a complete solution.)

You are planning the configuration of an IPsec-protected connection between two routers. You are concerned
only with the integrity of the data that passes between the routers. You are less concerned with the
confidentiality of the data, and you would like to minimize the effect of IPsec on the data throughput.
Which protocol option should you choose?

Which Cisco IOS command allows you to change the setting of the configuration register?

You have a router that is not syncing with its configured time source.
Which of the following is NOT a potential reason for this problem?