which ports will receive the frame?
A switch that you manage has three VLANs configured. Its MAC address table is shown below:
Vlan Mac address Type Ports
<output omitted>
1 000f.e544.c2b3 dynamic Fa0/10
1 000d.4589.00b8 dynamic Fa0/5
1 00bd.000b.005bb dynamic Fa0/8
11 0001.0d44.bbdb dynamic Fa0/12
55 0014.0bd4.0054 dynamic Fa0/15
66 00bb.224b.0ac5 dynamic Fa0/1
You execute the following command on the switch:
Switch# show int trunk
Port mode Encapsulation Status Native VLANFa0/10 on 802.1q trunking 1
Fa0/5 on 802.1q trunking 1
Fa0/8 on 802.1q trunking 1
Considering only the ports listed in the output, if a frame enters the switch untagged with a destination address
of 0002.254b.0015, which ports will receive the frame? (Choose all that apply.)
Which Cisco IOS command will enable a switch to copy th…
Which Cisco IOS command will enable a switch to copy the configuration from NVRAM to its RAM?
Which command(s) will enable you to configure only seri…
Which command(s) will enable you to configure only serial interface 0 on a Cisco router?
Which of the following situations could cause a switch …
Which of the following situations could cause a switch to enter initial configuration mode upon booting?
What command should you use?
You have a Telnet session established with a switch from a router. You would like to maintain that connection
while you return to the session with the router, and then easily return to the switch session after connecting to
the router.
What command should you use?
Which of the following can be determined from this output?
The execution of the show interfaces command yields the following as a part of its output:
Ethernet 0/0 is up, line protocol is down
Which of the following can be determined from this output?
Which of the following is a probable cause for this sce…
A new switch is added to the network, and several production VLANs are shut down.
Which of the following is a probable cause for this scenario? (Choose two.)
which two statements are TRUE?
Router-A# show running-configuration s0/0
interface serial0/0
description connected to router A
IP address 10.10.10.1 255.0.0.0
encapsulation frame-relay
shutdown
clock rate 64000
Based on the interface configuration provided, which two statements are TRUE? (Choose two.)
Click and drag the correct network ID from the left to the appropriate subnet…
DRAG DROP
Click the Exhibits button at the bottom of the page to examine a proposed network diagram. There are four
proposed subnets, labeled A, B, C, and D. Subnet A will have 12 users, subnet B will have 300 users, subnet C
will have 118 users, and subnet D will have 61 users.
You are designing the IP addressing for this network. You are instructed not to waste IP addresses by making
the subnets larger than necessary. Click and drag the correct network ID from the left to the appropriate subnet
on the right.
Select and Place:
Which statements are TRUE regarding Internet Protocol v…
Which statements are TRUE regarding Internet Protocol version 6 (IPv6) addresses? (Choose three.)