You are the switch administrator for InterConn. The network is physically wired as shown in the diagram. You
are planning the configuration of STP. The majority of network traffic runs between the hosts and servers within
each VLAN.

You would like to designate the root bridges for VLANS 10 and 20. Which switches should you designate as the
root bridges?

You are a network administrator for your organization. Your organization has two Virtual LANs (VLANs) named
Marketing and Production. All switches in the network have both VLANs configured on them. Switches A, C, F,
and G have user machines connected for both VLANs, while switches B, D, and E have user machines
connected for the Production VLAN only. (Click the Exhibit(s) button to view the network diagram.)

To reduce broadcast traffic on the network, you want to ensure that broadcasts from the Marketing VLAN are
flooded only to those switches that have Marketing VLAN users.
Which Cisco switch feature should you use to achieve the objective?

Which Cisco IOS command would produce the following output?

You need to set the Telnet password to “john” on a Cisco router. Which set of commands would you use?

Based on the output of the show mac-address-table command shown below, where will the switch that
produced this output send a frame with a destination MAC address of ffff.ffff.ffff?
Vlan Mac address Type Ports
<output omitted>
1 000f.e544.c2b3 dynamic Fa0/10
1 000d.4589.00b8 dynamic Fa0/5
1 00bd.000b.005bb dynamic Fa0/8
1 0001.0d44.bbdb dynamic Fa0/12
1 0014.0bd4.0054 dynamic Fa0/15
1 00bb.224b.0ac5 dynamic Fa0/1

What is the significance of the 1 in the following configuration?
router(config)# router eigrp 1

Which of the following commands would allow you to determine the bandwidth of an interface?

Which protocol is responsible for negotiating and maintaining Point-to-Point Protocol (PPP) connections?

You are the network administrator for your company. You wanted to connect the host computers to the
switches.
Which cable should you use to ensure the connectivity?

You have added a new router to your network using all of the default settings. You can connect to everything by
IP address, but the router doesn’t seem to be resolving names to IP addresses. The DNS server is in a directly
connected network.
Which of the following is most likely the problem?