You are configuring all your devices for IPv6. Which of the following is the only device that requires the ipv6
unicast-routing command?

Which Cisco IOS command would prompt for input in the following format?

Which of the following statements are NOT part of the guidelines for configuring VLAN Trunking Protocol (VTP)
to ensure that VLAN information is distributed to all Cisco switches in the network? (Choose all that apply.)

What command produced the following output?

DRAG DROP
Click and drag the components on the left to their appropriate descriptions on the right.
Select and Place:

You have discovered that Router 8 on your network is not receiving updates from Router 10. Router10 has an
IP address of 201.56.41.9. All routers run RIP. Since you are new and not completely familiar with the topology
of the network, you execute the debug ip rip command on Router 8 and receive the results shown below:
Router8# debug ip rip
*Mar 1 07:35:12.070: RIP: sending v2 update to 201.56.41.9 via Serial0/0 (201.56.41.88)
*Mar 1 07:35:12.074: RIP: build update entries
*Mar 1 07:35:19.638: RIP: ignored v2 packet from 201.56.41.9 (invalid authentication)
What can be the problem? (Choose all that apply.)

You are considering a candidate for a job as a Cisco network technician. As part of the assessment process,
you ask the candidate to write down the commands required to configure a serial interface, in the proper order
with the correct command prompts. The candidate submits the set of commands shown below (line numbers
are for reference only):
1 Router# configure terminal
2 Router(config)# interface S0
3 Router(config)# ip address 192.168.5.5
4 Router(config-if)# enable interface
5 Router(config-if)# description T1 to Raleigh
What part(s) of this submission are incorrect? (Choose all that apply.)

Which command is used on the Cisco Catalyst 2950 series switch to configure a port as a VLAN trunk port?