One Comment on “Which R75 GUI would you use to see the number of packets accepted since the last policy install?”

1. David says:

   August 7, 2013 at 1:19 am

   I don’t see where the “number of packets accepted since the last policy install” is in SmartView Monitor on an R75.46 Check Point Firewall. I do however see “the number of packets that arrived since the firewall was restarted” by going to SmartView Monitor -> All -> Click on Active Node -> Click “Network Activity”. The packet counts in the Traffic Interfaces Table count is since the firewall was restarted, not since the last policy push. Am I looking for this in the correct area of SmartView Monitor?

   
   
   
   0

   
   
   
   0