When translation occurs using automatic Hide NAT, what also happens?

The fw monitor utility is used to troubleshoot which of the following problems?

In SmartDashboard, Translate destination on client side is checked in Global Properties. When
Network Address Translation is used:

Secure Internal Communications (SIC) is completely NAT-tolerant because it is based on:

Static NAT connections, by default, translate on which firewall kernel inspection point?

You are MegaCorp’s Security Administrator. There are various network objects which must be
NATed. Some of them use the Automatic Hide NAT method, while others use the Automatic Static
NAT method. What is the rule order if both methods are used together? Give the BEST answer.

Which answers are TRUE? Automatic Static NAT CANNOT be used when:
1) NAT decision is based on the destination port.
2) Both Source and Destination IP’s have to be translated.
3) The NAT rule should only be installed on a dedicated Gateway.

4) NAT should be performed on the server side.

After filtering a fw monitor trace by port and IP, a packet is displayed three times; in the i, I, and o
inspection points, but not in the O inspection point. Which is the likely source of the issue?

Your internal network is configured to be 10.1.1.0/24. This network is behind your perimeter R77
Gateway, which connects to your ISP provider. How do you configure the Gateway to allow this
network to go out to the Internet?

You enable Automatic Static NAT on an internal host node object with a private IP address of
10.10.10.5, which is NATed into 216.216.216.5. (You use the default settings in Global Properties
/ NAT.)
When you run fw monitor on the R77 Security Gateway and then start a new HTTP connection
from host 10.10.10.5 to browse the Internet, at what point in the monitor output will you observe
the HTTP SYN-ACK packet translated from 216.216.216.5 back into 10.10.10.5?