In the process of troubleshooting traffic issues across a VPN tunnel, you notice on the output of
fw monitor -e host(172.21.1.10), accept; that packets are going through the inbound chain (i > I)
and then disappearing after the outbound chain (o > __), while you were expecting to see the
packet leave on O. What could be causing this issue?

You are troubleshooting your VPN and are reviewing the output of your command fw monitor,
shown below. What can you determine from the following output?

What would the following command fw monitor tell you?

After disabling SecureXL you ran command fw monitor to help troubleshoot a VPN issue. In your
review you note that you only see pre-inbound traffic (“i”) and no other traffic after this. Which of
the following reasons could explain this output?

You are setting up VPN between two gateways Local-GW and New-GW and want to use shared
secret. For some reason New-GW is not showing up in the shared secret properties under mesh
community properties. What is the most likely reason why the New-GW is not displayed?

SecureXL uses templating to accelerate traffic passing through the gateway. What command
should you run to determine if Accept, Drop and NAT templating is enabled?

Certain rules will disable connection rate acceleration (templates) in the Rule Base. What
command should be used to determine on what rule templates are disabled?

Look at the follow Rule Base display. Rule 5 contains a TIME object. What is the effect on the
following rules?

The command fwaccel stat displays what information?

When running a SecureXL debug how do you initialize the debug buffer to 32000?