By default, the Cluster Control Protocol (CCP) uses this to send delta sync messages to other cluster
members.

To configure the Cluster Control Protocol (CCP) to use Broadcast, the following command is run:

What cluster mode is represented in this case?

What cluster mode is represented in this case?

Which of the listed load-balancing methods is NOT valid?

Which method of load balancing describes “Round Robin”?

In New Mode HA, the internal cluster IP VIP address is 10.4.8.3. The internal interfaces on two
members are 10.4.8.1 and 10.4.8.2. Internal host 10.4.8.108 Pings 10.4.8.3, and receives replies.

Review the ARP table from the internal Windows host 10.4.8.108. According to the output, which
member is the standby machine?

In New Mode HA, the internal cluster IP VIP address is 10.4.8.3. An internal host
10.4.8.108 successfully pings its Cluster and receives replies. Review the ARP table from the internal
Windows host 10.4.8.108. Based on this information, what is the active cluster member’s IP address?

State Synchronization is enabled on both members in a cluster, and the Security Policy is successfully
installed. No protocols or services have been unselected for selective sync. Review the fw tab -t
connections -s output from both members.

Is State Synchronization working properly between the two members?

You have two IP Appliances: one IP565 and one IP395. Both appliances have IPSO 6.2 and R76
installed in a distributed deployment. Can they be members of a Gateway Cluster?