Your expanding network currently includes ClusterXL running Multicast mode on two
members, as shown in this topology: You need to add interfaces: 10.10.10.1/24 on Member
A, and 10.10.10.2/24 on Member b. The virtual IP address for these interfaces is
10.10.10.3/24. Both cluster gateways have a Quad card with an available eth3 interface.
What is the correct procedure to add these interfaces?

Use the table to match the BEST Management High Availability synchronication-status
descriptions for your Security Management Server (SMS).

MegaCorps’ disaster recovery plan is past due for an update to the backup and restore
section to enjoy the benefits of the new distributed R77 installation. You must propose a
plan that meets the following required and desired objectives: RequireD. Security Policy
repository must be backed up no less frequently than every 24 hours. DesireD. Back up
R77 components enforcing the Security Policies at least once a week. DesireD. Back up
R77 logs at least once a week. You develop a disaster recovery plan proposing the
following: * Use the utility cron to run the command upgrade_export each night on the
Security Management Servers. * Configure the organization’s routine backup software to
back up files created by the command upgrade_export. * Configure GAiA back up utility to
back up Security Gateways every Saturday night. * Use the utility cron to run the command
upgrade_export each Saturday night on the log servers. * Configure an automatic, nightly
logswitch. * Configure the organization’s routine back up software to back up the switched
logs every night. The corporate IT change review committee decides your plan:

Match the VPN-related terms with their definitions. Each correct term is only used once.

To provide full connectivity upgrade status, use command

In a zero downtime firewall cluster environment, what command syntax do you run to avoid
switching problems around the cluster for command cphaconf?

In a zero downtime scenario, which command do you run manually after all cluster
members are upgraded?

Complete this statement. To save interface information before upgrading a Windows
Gateway, use command

Fill in the blank with a numeric value. The default port number for standard TCP
connections with the LDAP server is

Fill in the blank with a numeric value. The default port number for Secure Sockets Layer
(SSL) connections with the LDAP Server is