An internal router is sending UDP keep-alive packets that are being encapsulated with GRE and sent through your R70 Security Gateway to a partner site. A rule for GRE traffic is configured for ACCEPT/LOG. Although the keep-alive packets are being sent every 1 minute, a search through the SmartView Tracker logs for GRE traffic only shows one entry for the whole day (early in the morning after a Policy install).

Your partner site indicates they are successfully receiving the GRE encapsulated keep-alive packets on the 1-minute interval.

If GRE encapsulation is turned off on the router, SmartView Tracker shows a log entry for the UDP keep-alive packet every minute.

Which of the following is the BEST explanation for this behavior?

What are the results of the commanD. fw sam [Target IP Address]?

Which command allows Security Policy name and install date verification on a Security Gateway?

How do you use SmartView Monitor to compile traffic statistics for your company’s Internet activity during production hours?

In the Security Policy shown here, which rule inhibits Rule 4?

What will happen when Reset is pressed and confirmed in the Trust Communication window launched from the Gateway object?

[tagged]
What information is found in the SmartView Tracker Management log?

How can you activate the SNMP daemon on a Check Point Security Gateway?

One of your remote Security Gateway’s suddenly stops sending logs, and you cannot install the Security Policy on the Gateway. All other remote Security Gateways are logging normally to the Security Management Server, and Policy installation is not affected. When you click the Test SIC status button in the problematic Gateway object you receive an error message. What is the problem?

How can you reset the Security Administrator password that was created during initial Security Management Server installation on SecurePlatform?