What should you look for?
A client has created a new Gateway object that will be managed at a remote location. When the client attempts to install the Security Policy to the new Gateway object, the object does not appear in the Install On check box. What should you look for?
Which SmartConsole application will tell you which Security Gateways have licenses that will expire within the
Your bank’s distributed R75 installation has Security Gateways up for renewal. Which SmartConsole application will tell you which Security Gateways have licenses that will expire within the next 30 days?
what point in the monitor output will you observe the HTTP SYN-ACK packet translated from 216.216.216.5 back i
You enable Automatic Static NAT on an internal host node object with a private IP address of 10.10.10.5, which is NATed into 216.216.216.5. (You use the default settings in Global Properties / NAT.)
When you run fw monitor on the R75 Security Gateway and then start a new HTTP connection from host 10.10.10.5 to browse the Internet, at what point in the monitor output will you observe the HTTP SYN-ACK packet translated from 216.216.216.5 back into 10.10.10.5?
What is the problem and what can be done about it?
You have configured a remote site Gateway that supports your boss’s access from his home office using a DSL dialup connection. Everything worked fine yesterday, but today all connectivity is lost. Your initial investigation results in “nobody has touched anything”, which you can support by taking a look in SmartView Tracker Management. What is the problem and what can be done about it?
A digital signature:
A digital signature:
Do you above settings limit the partner’s access?
You are a Security Administrator who has installed Security Gateway R75 on your network. You need to allow a specific IP address range for a partner site to access your intranet Web server. To limit the partner’s access for HTTP and FTP only, you did the following:
1. Created manual Static NAT rules for the Web server.
2. Created the following settings in the Global Properties’ Network Address Translation screen
– Allow bi-directional NAT*
– Translate destination on client side
Do you above settings limit the partner’s access?
Which SmartConsole application should you use to confirm your suspicions?
You believe Phase 2 negotiations are failing while you are attempting to configure a site-to-site VPN with one of your firm’s business partners. Which SmartConsole application should you use to confirm your suspicions?
Which specific R75 GUI would you use to add an address translation rule?
[tagged]
Which specific R75 GUI would you use to add an address translation rule?
Which of the following uses the same key to decrypt as it does to encrypt?
Which of the following uses the same key to decrypt as it does to encrypt?
In order for the Security Management Server to install a policy to the Firewall, an explicit rule must be crea
In a distributed management environment, the administrator has removed the default check from Accept Control Connections under the Policy / Global Properties / FireWall tab. In order for the Security Management Server to install a policy to the Firewall, an explicit rule must be created to allow the server to communicate to the Security Gateway on port ______.