Your network is experiencing connectivity problems and you want to verify if routing problems are
present. You need to disable the firewall process but still allow routing to pass through the
Gateway running on an IP Appliance running IPSO. What command do you need to run after
stopping the firewall service?

Which utility allows you to configure the DHCP service on SecurePlatform from the command line?

The third-shift Administrator was updating Security Management Server access settings in Global
Properties and testing. He managed to lock himself out of his account. How can you unlock this
account?

The third-shift Administrator was updating Security Management Server access settings in Global
Properties. He managed to lock all administrators out of their accounts. How should you unlock
these accounts?

You are the Security Administrator for ABC-Corp. A Check Point Firewall is installed and in use on
SecurePlatform. You are concerned that the system might not be retaining your entries for the
interfaces and routing configuration. You would like to verify your entries in the corresponding
file(s) on SecurePlatform. Where can you view them? Give the BEST answer.

When using SecurePlatform, it might be necessary to temporarily change the MAC address of the
interface eth 0 to 00:0C:29:12:34:56. After restarting the network the old MAC address should be
active. How do you configure this change?

Several Security Policies can be used for different installation targets. The Firewall protecting
Human Resources’ servers should have its own Policy Package. These rules must be installed on
this machine and not on the Internet Firewall. How can this be accomplished?

Where is the IPSO Boot Manager physically located on an IP Appliance?

How is wear on the flash storage device mitigated on diskless appliance platforms?

Your R76 primary Security Management Server is installed on GAiA. You plan to schedule the
Security Management Server to run fw logswitch automatically every 48 hours. How do you create
this schedule?