What happens when you run the commanD. fw sam -J src [Source IP Address]?

An internal router is sending UDP keep-alive packets that are being encapsulated with GRE and
sent through your R76 Security Gateway to a partner site. A rule for GRE traffic is configured for
ACCEPT/LOG. Although the keep-alive packets are being sent every minute, a search through the
SmartView Tracker logs for GRE traffic only shows one entry for the whole day (early in the
morning after a Policy install).
Your partner site indicates they are successfully receiving the GRE encapsulated keep-alive
packets on the 1-minute interval.
If GRE encapsulation is turned off on the router, SmartView Tracker shows a log entry for the UDP
keep-alive packet every minute.
Which of the following is the BEST explanation for this behavior?

Which port must be allowed to pass through enforcement points in order to allow packet logging to
operate correctly?

You are the Security Administrator for MegaCorp and would like to view network activity using
SmartReporter. You select a standard predefined report. As you can see here, you can select the
london Gateway.

When you attempt to configure the Express Report, you are unable to select this Gateway.

What is the reason for this behavior? Give the BEST answer.

In SmartView Tracker, which rule shows when a packet is dropped due to anti-spoofing?

In SmartView Tracker, which rule shows when a packet is dropped due to anti-spoofing?

A third-shift Security Administrator configured and installed a new Security Policy early this
morning. When you arrive, he tells you that he has been receiving complaints that Internet access
is very slow. You suspect the Security Gateway virtual memory might be the problem. Which
SmartConsole component would you use to verify this?

You find a suspicious connection from a problematic host. You decide that you want to block
everything from that whole network, not just the problematic host. You want to block this for an
hour while you investigate further, but you do not want to add any rules to the Rule Base. How do

you achieve this?

In SmartDashboard, you configure 45 MB as the required free hard-disk space to accommodate
logs. What can you do to keep old log files, when free space falls below 45 MB?

How do you configure an alert in SmartView Monitor?