Your main internal network 10.10.10.0/24 allows all traffic to the Internet using Hide NAT. You also
have a small network 10.10.20.0/24 behind the internal router. You want to configure the kernel to
translate the source address only when network 10.10.20.0 tries to access the Internet for HTTP,
SMTP, and FTP services. Which of the following configurations will allow this network to access
the Internet?

You have three servers located in a DMZ, using private IP addresses. You want internal users
from 10.10.10.x to access the DMZ servers by public IP addresses. Internal_net 10.10.10.x is
configured for Hide NAT behind the Security Gateway’s external interface.

What is the best configuration for 10.10.10.x users to access the DMZ servers, using the DMZ
servers’ public IP addresses?

An internal host initiates a session to and is set for Hide NAT behind the Security Gateway. The
initiating traffic is an example of ____________.

A host on the Internet initiates traffic to the Static NAT IP of your Web server behind the Security
Gateway. With the default settings in place for NAT, the initiating packet will translate the
_________.

A Web server behind the Security Gateway is set to Automatic Static NAT. Client side NAT is not
checked in the Global Properties. A client on the Internet initiates a session to the Web Server.
Assuming there is a rule allowing this traffic, what other configuration must be done to allow the
traffic to reach the Web server?

When translation occurs using automatic Hide NAT, what also happens?

The fw monitor utility is used to troubleshoot which of the following problems?

Looking at the SYN packets in the Wireshark output,

select the statement that is true about NAT.

In SmartDashboard, Translate destination on client side is checked in Global Properties. When
Network Address Translation is used:

Secure Internal Communications (SIC) is completely NAT-tolerant because it is based on: