Which of the following is a likely explanation for this?
You are trying to save a custom log query in R75 SmartView Tracker, but getting the following error “Could not save ‘query-name’ (Error Database is Read only).
Which of the following is a likely explanation for this?
What would be the benefit of upgrading from SmartDefense to IPS R75?
What would be the benefit of upgrading from SmartDefense to IPS R75?
Which R75 GUI would you use to see the number of packets accepted since the last policy install?
Which R75 GUI would you use to see the number of packets accepted since the last policy install?
R75’s INSPECT Engine inserts itself into the kernel between which two layers of the OSI model?
R75’s INSPECT Engine inserts itself into the kernel between which two layers of the OSI model?
Where do you enable popup alerts for IPS settings that have detected suspicious activity?
Where do you enable popup alerts for IPS settings that have detected suspicious activity?
Once installed, the R75 kernel resides directly below which layer of the OSI model? Note:
Once installed, the R75 kernel resides directly below which layer of the OSI model? Note:
Application is the top and Physical is the bottom of the IP stack.
What information is found in the SmartView Tracker Management log?
What information is found in the SmartView Tracker Management log?
How could Jon configure DNS servers now that his Security Gateway is in production?
When Jon first installed the system, he forgot to configure DNS servers on his Security Gateway.
How could Jon configure DNS servers now that his Security Gateway is in production?
What is the correct order of steps needed to perform this?
While in Smart View Tracker, Brady has noticed some very odd network traffic that he thinks could be an intrusion. He decides to block the traffic for 60 but cannot remember all the steps. What is the correct order of steps needed to perform this?
1) Select the Active Mode tab In Smart view Tracker
2) Select Tools > Block Intruder
3) Select the Log Viewing tab in SmartView Tracker
4) Set the Blocking Time out value to 60 minutes
5) Highlight the connection he wishes to block
What is wrong?
You are running the Security Gateway on SecurePlatform and configure SNX with default settings. The client fails to connect to the Security Gateway. What is wrong?