Because of pre-existing design constraints, you set up manual NAT rules for your HTTP server.
However, your FTP server and SMTP server are both using automatic NAT rules. All traffic from
your FTP and SMTP servers are passing through the Security Gateway without a problem, but
traffic from the Web server is dropped on rule 0 because of anti-spoofing settings. What is causing
this?

You enable Hide NAT on the network object, 10.1.1.0 behind the Security Gateway’s external
interface. You browse to from host, 10.1.1.10 successfully. You enable a log on the rule that
allows 10.1.1.0 to exit the network. How many log entries do you see for that connection in
SmartView Tracker?

Which of the following statements BEST describes Check Point’s Hide Network Address
Translation method?

Which Check Point address translation method allows an administrator to use fewer ISP-assigned
IP addresses than the number of internal hosts requiring Internet connectivity?

NAT can NOT be configured on which of the following objects?

Which Check Point address translation method is necessary if you want to connect from a host on
the Internet via HTTP to a server with a reserved (RFC 1918) IP address on your DMZ?

You want to implement Static Destination NAT in order to provide external, Internet users access
to an internal Web Server that has a reserved (RFC 1918) IP address. You have an unused valid
IP address on the network between your Security Gateway and ISP router. You control the router
that sits between the firewall external interface and the Internet.
What is an alternative configuration if proxy ARP cannot be used on your Security Gateway?

After implementing Static Address Translation to allow Internet traffic to an internal Web Server on
your DMZ, you notice that any NATed connections to that machine are being dropped by antispoofing protections. Which of the following is the MOST LIKELY cause?

Which NAT option applicable for Automatic NAT applies to Manual NAT as well?

Your main internal network 10.10.10.0/24 allows all traffic to the Internet using Hide NAT. You also
have a small network 10.10.20.0/24 behind the internal router. You want to configure the kernel to
translate the source address only when network 10.10.20.0 tries to access the Internet for HTTP,
SMTP, and FTP services. Which of the following configurations will allow this network to access
the Internet?