What is the command to show OSPF adjacencies?

A VPN Tunnel Interface (VTI) is defined on SecurePlatform Pro as:
vpn shell interface add numbered 10.10.0.1 10.10.0.2 madrid.cp
What do you know about this VTI?

Which of the following operating systems support numbered VTI’s?

Which type of routing relies on a VPN Tunnel Interface (VTI) to route traffic?

Which type of routing relies on a VPN Tunnel Interface (VTI) to route traffic?

You have installed SecurePlatform R76 as Security Gateway operating system. As company
requirements changed, you need the VTI features of R76. What should you do?

Which operating system(s) support(s) unnumbered VPN Tunnel Interfaces (VTIs) for route-based
VPN’s?

You have three Gateways in a mesh community. Each gateway’s VPN Domain is their internal
network as defined on the Topology tab setting All IP Addresses behind Gateway based on
Topology information.
You want to test the route-based VPN, so you created VTIs among the Gateways and created
static route entries for the VTIs. However, when you test the VPN, you find out the VPN still go
through the regular domain IPsec tunnels instead of the routed VTI tunnels.
What is the problem and how do you make the VPN use the VTI tunnels?

When configuring a Permanent Tunnel between two gateways in a Meshed VPN community, in
what object is the tunnel managed?

Which of the following commands would you run to remove site-to-site IKE and IPSec Keys?