How do you set up Port Address Translation?

You have set up a manual NAT rule, however fw monitor shows you that the device still uses the
automatic Hide NAT rule. How should you correct this?

Since R76 GAiA, what is the method for configuring proxy ARP entries for manual NAT rules?

Tom is troubleshooting NAT issues using fw monitor and Wireshark. He tries to initiate a
connection from the external network to a DMZ server using the public IP which the firewall
translates to the actual IP of the server. He analyzes the captured packets using Wireshark and
observes that the destination IP is being changed as required by the firewall but does not see the
packet leave the external interface. What could be the reason?

Tom has a Web server for which he has created a manual NAT rule. The rule is not working. He
tries to initiate a connection from the external network to a DMZ server using the public IP which
the firewall translates to the actual IP of the server. He analyzes the captured packets using

Wireshark and observes that the destination IP is being changed as required by the firewall but
does not see the packet leave the internal interface. Which box in Global Properties should be
checked?

Which FW-1 kernel flags should be used to properly debug and troubleshoot NAT issues?

Which file should be edited to modify ClusterXL VIP Hide NAT rules, and where?

When viewing a NAT Table, What represents the second hexadecimal number of the 6-tuple:

By default, the size of the fwx_alloc table is:

Given the screen configuration shown, the failure’s probable cause is: