how do you turn this debug off?
When finished running a debug on the Management Server using the command fw debug fwm
on how do you turn this debug off?
Which commands will properly set the debug level to maximum and then run a policy install in debug mode for th
Which commands will properly set the debug level to maximum and then run a policy install in
debug mode for the policy Standard on gateway A-GW from an R77 GAiA Management Server?
Which of the following items is NOT part of the columns of the chain modules?
Which of the following items is NOT part of the columns of the chain modules?
To obtain information about the issue, John runs the command:
John is a Security Administrator of a Check Point platform. He has a mis-configuration issue that
points to the Rule Base. To obtain information about the issue, John runs the command:
What is the error cause?
When troubleshooting and trying to understand which chain is causing a problem on the Security Gateway, you sh
When troubleshooting and trying to understand which chain is causing a problem on the Security
Gateway, you should use the command:
Which process should you debug when SmartDashboard authentication is rejected?
Which process should you debug when SmartDashboard authentication is rejected?
What prevents the customer from logging into SmartDashboard?
which directory are the logs written?
When performing a fwm debug, to which directory are the logs written?
How would you confirm if the traffic is actually being dropped by the gateway?
You are attempting to establish an FTP session between your computer and a remote server, but
it is not being completed successfully. You think the issue may be due to IPS. Viewing
SmartView Tracker shows no drops. How would you confirm if the traffic is actually being
dropped by the gateway?