CORRECT TEXT
Type the full fw command and syntax that allows you to disable only sync on a cluster firewall member.

CORRECT TEXT
Type the command and syntax you would use to verify that your Check Point cluster is functioning
correctly.

CORRECT TEXT
Type the command and syntax that you would use to view the virtual cluster interfaces of a
ClusterXL environment.

CORRECT TEXT
Type the command and syntax to view critical devices on a cluster member in a ClusterXL
environment.

CORRECT TEXT
Type the command and syntax to configure the Cluster Control Protocol (CCP) to use Broadcast.

CORRECT TEXT
Fill in the blank. In New Mode HA, the internal cluster IP VIP address is 10.4.8.3. The internal
interfaces on two members are 10.4.8.1 and 10.4.8.2 Internal host 10.4.8.108 pings 10.4.8.3, and
receives replies.
Review the ARP table from the internal Windows host 10.4.8.108. According to the output, which member is the standby machine?

CORRECT TEXT
Fill in the blank. In New Mode HA, the internal cluster IP VIP address is 10.4.8.3. An internal host
10.4.8.108 successfully pings its Cluster and receives replies.
Review the ARP table from the internal Windows host 10.4.8.108. Based on this information, what
is the active cluster member’s IP address?

CORRECT TEXT
Fill in the blank. In Load Sharing Unicast mode, the internal cluster IP address is 10.4.8.3. The
internal interfaces on two members are 10.4.8.1 and 10.4.8.2. Internal host 10.4.8.108 Pings
10.4.8.3, and receives replies. The following is the ARP table from the internal Windows host
10.4.8.108.
Review the exhibit and type the IP address of the member serving as the pivot machine in the space below.

CORRECT TEXT
To stop acceleration on a GAiA Security Gateway, enter command:

CORRECT TEXT
To bind a NIC to a single processor when using CoreXL on GAiA, you would use the command