How do you recover communications between your Security Management Server and Security Gateway if you lock you
How do you recover communications between your Security Management Server and Security
Gateway if you lock yourself out through a rule or policy mis-configuration?
How can you check whether IP forwarding is enabled on an IP Security Appliance?
How can you check whether IP forwarding is enabled on an IP Security Appliance?
Which command allows you to view the contents of an R76 table?
Which command allows you to view the contents of an R76 table?
Which of the following tools is used to generate a Security Gateway R76 configuration report?
Which of the following tools is used to generate a Security Gateway R76 configuration report?
Which of the following is a CLI command for Security Gateway R76?
Which of the following is a CLI command for Security Gateway R76?
Which of the following commands can be used in Expert Mode to configure the speed and duplex settings of an Et
You are the Security Administrator for MegaCorp. A Check Point firewall is installed and in use on a
platform using GAiA, You have trouble configuring the speed and duplex settings of your Ethernet
interfaces. Which of the following commands can be used in Expert Mode to configure the speed
and duplex settings of an Ethernet interface and will survive a reboot? Give the BEST answer.
SIC Certificates:
Select the correct statement about Secure Internal Communications (SIC) Certificates. SIC
Certificates:
how could you achieve these requirements?
Your perimeter Security Gateway’s external IP is 200.200.200.3. Your network diagram shows:
Required. Allow only network 192.168.10.0 and 192.168.20.0 to go out to the Internet, using
200.200.200.5.
The local network 192.168.1.0/24 needs to use 200.200.200.3 to go out to the Internet.
Assuming you enable all the settings in the NAT page of Global Properties, how could you achieve
these requirements?
What is causing this?
Because of pre-existing design constraints, you set up manual NAT rules for your HTTP server.
However, your FTP server and SMTP server are both using automatic NAT rules. All traffic from your
FTP and SMTP servers are passing through the Security Gateway without a problem, but traffic from
the Web server is dropped on rule 0 because of anti-spoofing settings. What is causing this?
How many log entries do you see for that connection in SmartView Tracker?
You enable Hide NAT on the network object, 10.1.1.0 behind the Security Gateway’s external
interface. You browse to www.google.com from host, 10.1.1.10 successfully. You enable a logon the
rule that allows 10.1.1.0 to exit the network. How many log entries do you see for that connection in
SmartView Tracker?