What would the following command fw monitor tell you?
What would the following command fw monitor tell you?
Which of the following reasons could explain this output?
After disabling SecureXL you ran command fw monitor to help troubleshoot a VPN issue. In
your review you note that you only see pre-inbound traffic (“i”) and no other traffic after this.
Which of the following reasons could explain this output?
What is the most likely reason why the New-GW is not displayed?
You are setting up VPN between two gateways Local-GW and New-GW and want to use
shared secret. For some reason New-GW is not showing up in the shared secret properties
under mesh community properties. What is the most likely reason why the New-GW is not
displayed?
What command should you run to determine if Accept, Drop and NAT templating is enabled?
SecureXL uses templating to accelerate traffic passing through the gateway. What
command should you run to determine if Accept, Drop and NAT templating is enabled?
what rule templates are disabled?
Certain rules will disable connection rate acceleration (templates) in the Rule Base. What
command should be used to determine on what rule templates are disabled?
What is the effect on the following rules?
Look at the follow Rule Base display. Rule 5 contains a TIME object. What is the effect on
the following rules?
what information?
The command fwaccel stat displays what information?
how do you initialize the debug buffer to 32000?
When running a SecureXL debug how do you initialize the debug buffer to 32000?
What command can be used to get the following output?
What command can be used to get the following output?
What command would you use to determine if a particular connection is being accelerated by SecureXL?
What command would you use to determine if a particular connection is being accelerated
by SecureXL?