From the output of the following cphaprob -i list, what is the most likely cause of the
clustering issue? Cluster B> cphaprob -i list Built-in Devices: Device Name: Interface Active
Check Current state: OK Device Name: HA Initialization Current state: OK Device Name:
Recovery Delay Current state: OK Registered Devices: Device Name: Synchronization
Registration number: 0 Timeout: none Current state: OK Time since last report: 3651.5 sec.
Device Name: Filter Registration number: 1 Timeout: none Current state: problem Time
since last report: 139 sec. Device Name: routed Registration number: 2 Timeout: none
Current state: OK Time since last report: 3651.9 sec. Device Name: cphad Registration
number: 3 Timeout: none Current state: OK Time since last report: 3696.5 sec. Device
Name: fwd Registration number: 4 Timeout: none Current state: OK Time since last report:
3696.5 sec.

Which command would a troubleshooter use to verify table connection info (peak,
concurrent) and verify information about cluster synchronization state?

Which definition best describes the file table.def function? It is a placeholder for:

Your customer receives an alert from their network operation center, they are seeing ARP
and Ping scans of their network originating from the firewall. What could be the reason for
the behaviour?

Your cluster member is showing a state of “Ready”. Which of the following is NOT a reason
one would expect for this behaviour?

Which of the following is NOT a cphaprob status?

What would be a reason for changing the “Magic MAC”?

What are the kernel parameters that control “Magic MACs”?

How many sync interfaces are supported on Check Point R77 GAiA?

Which is NOT a valid upgrade method in an R77 GAiA ClusterXL deployment?