Since switching your network to ISP redundancy you find that your outgoing static NAT

connections are failing. You use the command _________ to debug the issue.

Remote VPN clients can initiate connections with internal hosts, but internal hosts are
unable to initiate connections with the remote VPN clients, even though the policy is
configured to allow it. You think that this is caused by NAT. What command can you run to
see if NAT is occurring on a packet?

Where in a fw monitor output would you see source address translation occur in cases of
automatic Hide NAT?

Where in a fw monitor output would you see destination address translation occur in cases
of inbound automatic static NAT?

Which flag in the fw monitor command is used to print the position of the kernel chain?

Server A is subject to automatically static NAT and also resides on a network which is
subject to automatic Hide NAT. With regards to address translation what will happen when
Server A initiates outbound communication?

In your SecurePlatform configuration you need to set up a manual static NAT entry. After
creating the proper NAT rule what step needs to be completed?

How do you set up Port Address Translation?

You have set up a manual NAT rule, however fw monitor shows you that the device still
uses the automatic Hide NAT rule. How should you correct this?

Since R76 GAiA, what is the method for configuring proxy ARP entries for manual NAT
rules?