John is a Security Administrator of a Check Point platform. He has a mis-configuration issue
that points to the Rule Base. To obtain information about the issue, John runs the
command:

The user tried to connect in SmartDashboard and did not work. You started a FWM debug
and receive the logs below: What is the error cause?

When troubleshooting and trying to understand which chain is causing a problem on the
Security Gateway, you should use the command:

Which process should you debug when SmartDashboard authentication is rejected?

A fwm debug provides the following output. What prevents the customer from logging into
SmartDashboard?

When performing a fwm debug, to which directory are the logs written?

You are attempting to establish an FTP session between your computer and a remote
server, but it is not being completed successfully. You think the issue may be due to IPS.
Viewing SmartView Tracker shows no drops. How would you confirm if the traffic is actually
being dropped by the gateway?

The fw tab –t ___________ command displays the NAT table.

While troubleshooting a DHCP relay issue, you run a fw ctl zdebug drop and see the
following output: ;[cpu_1];[fw_0];fw_log_drop: Packet proto=17 10.216.14.108:67 >
172.31.2.1:67 dropped by fw_handle_first_packet Reason: fwconn_init_links (INBOUND)
failed; Where 10.216.14.108 is the IP address of the DHCP server and 172.31.2.1 is the VIP
of the Cluster. What is the most likely cause of this drop?

You are trying to troubleshoot a NAT issue on your network, and you use a kernel debug to
verify a connection is correctly translated to its NAT address. What flags should you use for
the kernel debug?