Refer to the exhibits on the Exhibit 1 and Exhibit 2 tabs.
Exhibit 1

Exhibit 2

Network clients are configured to use the switch as their default gateway in VLAN 2. The HP Comware
switch places VLAN 2 in OpenFlow instance 1. An SDN application has created the flow entry shown in
Exhibit 1 to route traffic from 10.1.2.0/24 to 10.1.3.0/24. Exhibit 1 does not show the output interface for the
flow.
Which output interface supports the needs of this scenario?

Refer to the exhibits on the Exhibit 1 and Exhibit 2 tabs.
Exhibit 1

Exhibit 2

A network administrator has set up an HP VAN SDN Controller to operate in hybrid mode. The
administrator wants to confirm that the controller has properly configured an HP Comware switch to be
controlled by it in hybrid mode. Which output in the exhibit indicates that the controller is using hybrid mode.

What correctly describes the role of OpenFlow in an SDN solution?

Refer to the exhibit.

A network administrator is setting up the OSPF routing for VPN instance “TenantA.” The configuration
shown in this exhibit is not functioning as expected. What must the administrator do to correct the
configuration?

A company is using HP Network Visualizer to monitor traffic transmitted and received by users in specific
Active Directory user groups. The company wants to send traffic to a different server from the controller and
have that server store the captured packets in PCAP format. How would the network administrator
configure this solution to meet these requirements?

An SDN application submits a username and password to authenticate to the HP VAN SDN Controller,
which is configured for local authentication. If the username and password are valid, what does the
controller do?

Which technology is best suited for isolating tenants within a data center that must support many tenants?

A network administrator is setting up OpenFlow settings on an HP ProVision switch with VLANs 1, 2, 3, and
4. The switch reaches the HP VAN SDN Controller on VLAN 1. The administrator wants to enable
OpenFlow on VLANs 2 and 3 but not on VLAN 4.
What is a valid configuration for the OpenFlow instances?

Refer to the exhibit.

Which design in the exhibit shows valid choices for HP switches?

Refer to the exhibits.

A network administrator has connected Comware-1 and Comware-2 on their Ten-GigabitEthernet 1/0/2
interfaces. The administrator configured both switches to support FCoE FCF mode and configured the
connecting interfaces to carry FCoE traffic. However, the configuration is not working.
The exhibit shows the output for several display commands. Based on this output, which step should the
administrator take to fix the problem?