How can the administrator access this interface?
A network administrator wants to configure an HP Provision switch from a menu interface. How can the
administrator access this interface?
Which commands can the administrator enter with this pr…
A network administrator logs into an HP Comware switch and receives user privilege level 0. Which commands
can the administrator enter with this privilege level?
What is the console port designation for an HP Comware …
What is the console port designation for an HP Comware switch?
Which access point (AP) type corresponds to HP MultiSer…
Which access point (AP) type corresponds to HP MultiService Mobility (MSM) autonomous operational mode?
Which wireless security should the administrator use?
A company is setting up a wireless network, and the network administrator wants to enforce the strongest
security possible. Which wireless security should the administrator use?
Which technology allows 802.11n to scale up to speeds o…
Which technology allows 802.11n to scale up to speeds of 600 Mbps?
What correctly describes the default support for spanni…
A network administrator is planning to add redundant links to a topology with HP Provision switches. What
correctly describes the default support for spanning tree?
what is the resulting Layer 2 topology?
Refer to the network exhibit
Switch_A and Switch_B are HP Comware switches currently in the same Multiple Spanning Tree Protocol
(MSTP) region with the following MSTP configuration:
•Region name: HP
•Revision number: 1
•Instance 1: VLANs 10 and 11
•Instance 2: VLANs 12 and 13
•Instance 0: VLANs 1-9 and 14-4094
MSTP is operating correctly on Switch_A and Switch_B. Switch_C and Switch_D are new Comwareswitches
and have been added to the network. The links between the switches are trunks, where VLAN 1 is the PVID
and all other VLANs are permitted on the trunks. The only STP command executed on the two new switches is
stp enable.
Based on this information, what is the resulting Layer 2 topology?
What must the administrator do first?
The exhibit shows the physical connection between two HP Comware switches and a server
The network administrator is concerned about redundancy and wants to implement a solution like that shown
on the right side of the exhibit. The administrator plans to use an LACP link aggregation with both links active.
What must the administrator do first?