How is the topology affected by this change?
Refer to the exhibit.
All of the switches in the exhibit are running Multiple Spanning Tree Protocol (MSTP). The ports that connect to
another switch are not boundary ports. All switches are configured as follows:• Config name = Region 1
• Revision number = 1
• Instance 1 =VLANs 10 and 12
• Instance 2 = VLANs 11 and 13
Currently, only VLANs 1, 10, 11, 12, and 13 exist on the four switches. A network administrator adds VLAN 15
to Switch_C. How is the topology affected by this change?
what is the behavior that the network administrator sho…
Refer to the exhibit.
Switch-1, an HP Comware switch, is connected to Switch-2, an HP ProVision switch on a link aggregation. The
exhibit shows the link aggregation status on both sides of the link. Based on the exhibit, what is the behavior
that the network administrator should expect?
What does the output indicate?
Refer to the exhibit.
A network administrator has created an HP Intelligent Resilient Framework (IRF) device with two members.
The members are connected on two interfaces, which are assigned to one IRF port on each member. The
administrator enters the command shown in the exhibit.
What does the output indicate?
What should the network administrator do to allow endpo…
Refer to the exhibit.
What should the network administrator do to allow endpoints to receive IP addresses from the network DHCP
server?
What should the administrator do to ensure that IMC can…
A network administrator wants to discover an HP MultiService Mobility (MSM) AP in HP Intelligent Management
Center (IMC). The MSM AP is operating in autonomous mode. What should the administrator do to ensure that
IMC can discover the AP?
What else must the administrator do to finish configuri…
A network administrator has started configuring DHCP relay on an HP Comware switch with these commands:
[Switch] dhcp enable
[Switch] interface vlan 10
[Switch-Vlan-interface10] dhcp select relay
What else must the administrator do to finish configuring DHCP relay?
Which type of information from the attached device can …
A device is connected to an HP Comware hybrid port. Which type of information from the attached device can
be used to assign it to a VLAN?
What should the administrator do to accomplish this?
Refer to the exhibit.
A network Administrator wants to ensure that all users in the Marketing department are in the same broadcast
domain. What should the administrator do to accomplish this?
which trend in today’s data center networks?
HP solutions help to meet the needs of which trend in today’s data center networks?
Which topologies does an HP Converged Campus support?
Which topologies does an HP Converged Campus support?