Refer to the exhibit.

A network architect is deciding whether to use a/24 subnet or a/25 subnet for each VLAN shown in
the exhibit. What is a valid reason for the architect to decide on a/24 subnet?

Refer to the exhibit.

Compare Design 1 and Design 2 shown in the exhibit. Which description is correct?

Refer to the exhibit.

The Intelligent Resilient Framework (IRF) virtual device is the default router for all clients, both
wired and wireless. The Unified Wired-WLAN Module controls the Aps, and wireless traffic is
distributed centrally. If IRF member 1 fails, which availability issue occurs?

Company executives believe that the company could benefit from letting employees connect their
own devices. The company also has high security pressures. Which approach to BYOD, defined
by Gartner, is best for this customer?

Refer to the exhibit.

The switches in this network are HP ProVision switches.
The network architect plans to set up Core 1 and Core 2 as distributed trunking (DT) switches.
What is an advantage of this design?

The HP partner has implemented an HP FlexNetwork solution for a customer. The partner is now
giving device inventories and physical and logical topologies to the customer. To which customer
role is this information most relevant?

A network architect has planned an 802.1X solution for a company with these requirements:
The solution authenticates employees who connect with wired connections.
The access layer switches are HP ProVision switches.
The core device is an HP Comware Intelligent Resilient Framework (IRF) virtual device.
The authentication server is HP IMC User Access Manager (UAM).
The company wants to keep this solution as it is but also allow the same ports to support guest
access. Instead of authenticating with 802.1X, guests should log in through a Web page hosted on
UAM.
Which solution meets this requirement?

A switch runs Open Shortest Path First (OSPF) on an interface and needs to establish an OSPF
adjacency or adjacencies on that interface. In which situation should the architect pay particular
attention to the OSPF hello timer and possibly tune it to a lower value?

Refer to the exhibit.

All switch interfaces shown in the exhibit have these characteristics:
Are configured in routed-mode
Have IP addresses
Run Open Shortest Path First (OSPF)
Network architect wants to ensure that routing switch 1 uses the faster link in preference to the
slower link, which should be used in failover situations. Which step should be architect perform to
meet this requirement?

A customer is installing HP ProLiant DL servers in an enterprise data center and wants to use HP
iLO to manage the servers remotely. What is recommended to support the use of iLO?