HOTSPOT
Match the characteristic to the routing protocol.

Refer to the exhibit.

A server connects to GigabitEthernet1/0/1 on an HP Comware switch. The server sends tagged
traffic in VLAN2. It has an application that sets the DiffServ Code Point (DSCP) for its traffic to 16

and the 802.1p value to 2. The switch should use the DSCP to place the traffic in priority queue.
The traffic belongs to the queue that is one priority level higher than the queue for best effort traffic
(traffic without a QoS value)
What can the network administrator do to meet this requirement?

HOTSPOT
Refer to the exhibit.

Switch 3 runs Rapid Per-VLAN Spanning Tree Plus (RPVST+), which is enabled on VLANs 1-4.
Select the correct number for each of these parameters.

Refer to the exhibits.
Exhibit 1

Exhibit 2

Exhibit 2 shows the Virtual Router Redundancy Protocol (VRRP) configuration and status for
VLAN 3 on switch 1 during normal operation, when both Switch 1 and Switch 2 are up. Switch 1
then experiences a power failure. After a few minutes, power is restored, and the switch comes
back up.
What happens to VRRP operations in VLAN 3?

Refer to the exhibit.

Router 4, which is an HP Comware router, redistributes Routing Information Protocol (RIP) routes
into Open Shortest Path First (OSPF) process 1. Router 4 has several dozen IP routes, and the
network administrator wants to minimize the number of external routes throughout the entire
OSPF AS. How can the administrator meet this requirement?