An HP Provision switch port is implementing MAC Authentication (MAC-Auth) to a RADIUS server.
A device connects to the port, and the switch submits a RADIUS Access-Request to the server.
What correctly describes how the switch determines the username and password for the request?

Refer to the exhibit.

The five routers shown in the exhibit are successfully implementing OSPF on the interface shown
in the exhibit. The exhibit also shows settings for OSPF areas and interface costs.
A network administrator enters these commands on Router 4 and Router 5:

How can the administrator ensures that Router 2 learns the route to 172.16.0.0/16 with next hop
10.0.0.6?

Refer to the exhibit.
Exhibit 1

Exhibit 2

Exhibit 1 shows a simplified network topology. All infrastructure devices shown in the exhibit are
successfully implementing (OSPF) on the interfaces. The exhibit also shows settings for OSPF
areas. Exhibit 2 shows additional settings on IRF. The master within IRF 1 fails. Connectivity is
disrupted for about one minute.
What can the network administrator do to prevent this issue occurring again?

A company plans to use Intelligent Management Center CMC) Network Traffic Analyzer (NTA) to
monitor network utilization. How do HP switches with the solution?

A company has configured two switches as an HP Intelligent Resilient Framework (IRF) virtual
device. The IRF port on each switch is bound to multiple physical links. How does the switch
select the link for transmitting packets on that IRF port?

Refer to the exhibits.
Exhibit 1

Exhibit 2

Exhibit 1 shows the SNMP template that HP Intelligent Management Center (IMC) will use when
discovering an HP Provision switch. Exhibit 2 settings on the switch. IMC should have rights to
read and write any parameter on the switch.
Which task must the network administrator complete to accomplish this?

A network administrator is configuring several HP Comware switches as an HP Intelligent Resilient
Framework (IRF) virtual device. According to best practices at, which point during the IRF
configuration process should the administrator activate the IRF ports?

Refer to the exhibit.

The five routers shown in the exhibit are successfully implementing OSPF on the interface shown
in the exhibit. The exhibit also shows settings for OSPF areas and interface costs.
A network administrator enters these commands on Router 4 and Router 5:

Which statement correctly describes the OSPF routing table on Router 2?

The network administrator is configuring Unidirectional Link Detection (UDLD) on trk1 on an HP
Provision witch. The trk1 link aggregation group has these settings:
Interfaces = 48 and 49
Untagged VUAN = 1
Tagged VLANs = 2-4

How should the administrator complete the setup?

A company wants to enforce source-specific multicasting (SSM) for several multicast streams.
This is the configuration:
Some multicast receivers support IGMPv3.
Other receivers that need to stream support IGMPv2 only.
The multicast receivers’ default routers enable IGMPv3 on the interfaces associated with their
subnets.
The routers are correctly configured to enable the IGMPv3 receivers to receive the stream from
the correct source
Which setting do the receivers’ routers require to support the IGMPV2 devices?