What can the network administrator do to prevent this issue from occurring again?
Refer to the exhibit.
IRF 3 and Switches 1, 2 and 4 are successfully implementing OSPF on the interfaces shown in the
exhibit. Then IRF 3’s 10.1.10/24 link fails. Connectivity between Server 1 and Server 2 is disrupted
for about 30 seconds.
What can the network administrator do to prevent this issue from occurring again?
Match the HP network infrastructure product to its HP FlexNetwork component.
HOTSPOT
Match the HP network infrastructure product to its HP FlexNetwork component.
How can the administrator correct the issue?
Refer to the exhibit.
Exhibit 1
Exhibit 2
The HP Intelligent Resilient Framework (IRF) virtual devices shown in the Exhibit 1 support traffic
for servers in VLAN 2-10. To enhance resiliency, the network administrator configures MAD on
both IRF virtual switches. The administrator has established the settings shown in the exhibit 2.
The configuration has an issue.
How can the administrator correct the issue?
What must the administrator check on any switches between the mirror source and destination?
A company has a network with HP Provision switches. The network administrator is establishing
remote mirroring session between two of the switches. The remote does not use the truncation
option.
What must the administrator check on any switches between the mirror source and destination?
How does Switch 1 handle the traffic received from Client 1?
Refer to the exhibit.
Exhibit 1
Exhibit 2
Client 1 is transmitting traffic to the data center.
Switch 3 transmits the traffic on the link to Switch 1.
How does Switch 1 handle the traffic received from Client 1?
Where must the administrator configure the static RP setting?
Refer to the exhibit.
A network administrator has begun configuring a Protocol Independent Multicast Sparse Mode
(PIM-SM) solution on all of the network infrastructure devices shown in the exhibit. The
administrator has selected the static method for configuring rendezvous (RPs) and wants to use 4 as RP.
Where must the administrator configure the static RP setting?
Which settings correctly configure the HP ProVision edge ports?
A company is implementing 802.1X authentication. These are the requirements:
Employees who pass 802.1X authentication should be placed VLAN 3.
Guests and employees who cannot authenticate, or fail authentication, should be placed in VLAN4.
Different users might connect to port at different times, but only one device will connect to the
port at the same time.
802.1X is enabled Globally on the switch (aaa port-access authenticator)
Which settings correctly configure the HP ProVision edge ports?
Where does Switch 1 transmit or process Bridge Protocol Data Units (BPDUs)?
Refer to the exhibit.
Switch 1 and Switch 2 have established and Interswitch Connection (ISC) and two distributed
trunks. All of the switches have Multiple Spanning tree Protocol (MSTP) enabled. Where does
Switch 1 transmit or process Bridge Protocol Data Units (BPDUs)?
which priority queue will the switch assign this frame?
Refer to the exhibit.
A network administrator is checking the Quality of Service (QoS) settings on an HP ProVision
Switch.
This frame arrives on the switch:
Ingress port: A1
No 802.1Q tag
Source IP address = 10.1.2.10
Destination IP address = 10.1.4.4
DSCP = 48
Destination TCP port = 5060
To which priority queue will the switch assign this frame? (Queues are numbered 0-7)
How does the switch handle the traffic?
Refer to the exhibit.
This HP 10500 Switch Series is receiving an average of 1 Gbps of HTTP traffic from 10.1.4.0/24.
The switch starts to receive an additional 1 Gbps of HTTP traffic from 10.1.4.0/24. How does the
switch handle the traffic?