A network administrator uses Telnet to log into an HP Comware switch and receives level 0 privileges. The
administrator enters super 3 and receives an error. What should administrators do to allow administrators to
use this command successfully in the future?

A network administrator enters this command on an HP Comware switch:
The administrator then checks the IP routing table and does not see the new IP route, as shown here:
Why is the new route missing from the table?

Refer to the exhibit.
A network administrator is creating a route to 10.1.2.0/24 on Switch-4. What is the correct next hop for the
route?

Refer to the exhibit.
The exhibit shows the IP routing table for an HP Provision switch. The network administrator then enters these
commands:
What is the result of this configuration?

A network administrator is performing auto discovery with Intelligent Management Center (IMC) to discover HP
switches. Which components should the administrator define in order to fully manage the discovered
networking devices?

Refer to the exhibit.
The network administrator wants to permit management access to Switch 2 through Switch 20 for HP Intelligent
Management Center (IMC). The 10 1.10.0/24 subnet only has 10 free addresses. What should the
administrator do to enable IMC to manage Switch 2 through Switch 20?