You enter the following command at the CLI of an HP E5412 zl Series switch:Switch(config)#
spanning-tree priority 3Which Bridge Priority value is
displayed when you enter show spanning-tree?

What is an advantage of using a ring topology when designing an IRF stack using A-Series
switches?

You must configure static link aggregation using LACP between an HP E5406 zl switch and an HP
E8212 zl switch. What must match on all ports that will
be included in the aggregated link? (Select three.)

Refer to the Exhibit.

What does the output shown in the exhibit indicate about this HP E3500-24G yl switch? (All
switches in the Spanning Tree are at default settings.)

Which HP E-Series switch models are chassis-based switches? (Select two.)

The front-panel security settings on an HP E5400 zl Series switch are at default. How can you
gain access to the CLI of the switch if the manager and
operator passwords have been lost?

What is the default protocol when a link aggregation group is defined on an HP A-Series switch?

You enter the following command at the CLI of an HP E5406 zl Series switch with IP routing
enabled:Switch(config)# router ripSwitch(rip)#Which
additional step is necessary to enable RIP functionality?

By default, which criteria are used for load-sharing of Layer 3 traffic over aggregated links
configured on HP A-Series switches?

What is the VLAN membership of wireless traffic exiting the bridge port on an HP E-MSM Access
Point with default VLAN settings?