Which view is indicated by the following prompt on an HP A7500 switch?[A7500]

On an HP A12500 switch, which type of port can support only one untagged VLAN and multiple
802.1Q VLANs?

Which type of port is typically used to support end users on an A-Series switch?

Refer to the Exhibit.

You have defined VLAN 5 and VLAN 6 on an HP E5406 zl switch. You have added four ports to
each VLAN as untagged members.
All other switch settings are at defaults. What must you do to enable communications between
hosts in the two VLANs?

Refer to the Exhibit.

The two switches in the exhibit are directly connected and have been pre-configured for MSTP.
When Spanning Tree is enabled
on the switches, how will they converge?

What is the default status of LLDP on an HP E5400 zl Series switch?

At a customer site, you enter the following command into the CLI of an HP A-Series switch: stp
bpdu-protectionWhich BPDUs will the switch discard?

The IP route table of an HP E5406 zl Series switch includes a route for 10.5.0.0/16 with a gateway
of 192.35.35.1. What is the effect of the following command?
Switch(config)# ip route 10.5.1.0/24 172.42.42.3

Refer to the Exhibit.

In the configuration shown in the exhibit, which users can access the web management interface
of the E5406 zl?

You must reset the startup configuration of an HP A-Series switch to factory defaults. Which CLI
view will enable you to complete this task?