What distinguishes an HP switch with a CLOS fabric from an HP switch with a crossbar fabric?

HP Comware Switch 1 connects to switch 2 on GigabitEthernet 1/0/1. Switch 2 implements an inbound rate
limit of 600 Mbps. The network administrator wants switch 1 to buffer traffic that exceeds the Switch 2 rate limit
of 600 Mbps and send the traffic at 600 Mbps. All traffic has the same 802.1p priority and is forwarded in priority
queue 2.
What should the administrator apply to the Switch 1 interface GigabitEthernet 1/0/1?

Two HP 10500 Series Switches connect on a 10G fiber link. One of the two fibers in the link breaks, and a
broadcast storm occurs. How could a network administrator prevent a problem like this from happening again?

Refer to the exhibit.

A network administrator up a remote mirroring on the HP Comware switches in the exhibit. The administrator
must define several port while entering mirroring-group commands on these switches. Which port should be the
reflector port (sometimes called monitor-egress port)?

A company needs a simple authenticate solution for guests. The HP Comware access layer switches will
implement portal authentication (or Web-Auth). The network administrator wants the switch to host the login
web page on an IP address that not used for any other purpose.
What should the administrator do to accomplish this goal?

Refer to the exhibit.

These three routers are currently configured for BGP. They do not apply any routing policy in terms of BGP on
routes or attributes advertised to an received from peers. How can the network administrator for Router 1 cause
Router 1 to advertise 192.0.2.0/24 to Router 2 and Router 3?

Refer to the exhibit.

An HP Comware Switch connects to Voice over (VoIP) phones. The phones connect to user’s computes, so
each switch port connects a computer and a phone.
These are the specifications:
The VLAN for data traffic is VLAN3
The VLAN for traffic VoIP is VLAN11
The phones support Link Layer Discovery Protocol (LLDP) Media Endpoint Detection (MED).The network administrator wants to use LLDP-MED to advertise the voice VLAN ID and priority settings to the
phones. The phones will then send tagged traffic in that VLAN. The switch should not check the incoming
traffic’s MAC address against its voice OID list. The exhibit shows the applicable switch port configuration.
Which additional step must the administrator complete to accomplish this?

A company uses 802.1X authentication to force users to authenticate to connect to the network. The company
uses HP IMC User Access manager (UAM) as the RADIUS server. The company wants to assign users to
VLANs based on their identity. For example, contractor should be assigned in VLAN 20. Assume that VLANs
are extended correctly across the network infrastructure.
Where does a network administrator configure the VLAN policy?

How does virtual output queuing (VoQ) help switches avoid head-of-line blocking and enhance throughput?

A company uses 802.1X authentication to force users to connect to the network. The company uses access
layer switches to enforce the 802.1X authentication and HP IMC User Access manager (UAM) as the RADIUS
server.
The customer requires switches to apply a specific settings to contractor use connections. The network
administrator checks the switch documentation and determines that this settings uses a vendor-specific
attribute (VSA). The administrator check UAN and verifies that it has this VSA defined on it.
How does administrator configure UAM to apply the correct setting?