Refer to the exhibit.

A network administrator is checking the Quality of Service (QoS) settings on an HP ProVision Switch.
This frame arrives on the switch:
Ingress port: A1
No 802.1Q tag
Source IP address = 10.1.2.10
Destination IP address = 10.1.4.4
DSCP = 48
Destination TCP port = 5060
To which priority queue will the switch assign this frame? (Queues are numbered 0-7)

Refer to the exhibit.

Switch 1 and Switch 2 have established and Interswitch Connection (ISC) and two distributed trunks. All of the
switches have Multiple Spanning tree Protocol (MSTP) enabled. Where does Switch 1 transmit or process
Bridge Protocol Data Units (BPDUs)?

A company is implementing 802.1X authentication. These are the requirements:
Employees who pass 802.1X authentication should be placed VLAN 3.
Guests and employees who cannot authenticate, or fail authentication, should be placed in VLAN4.
Different users might connect to port at different times, but only one device will connect to the port at the
same time.
802.1X is enabled Globally on the switch (aaa port-access authenticator)
Which settings correctly configure the HP ProVision edge ports?

Refer to the exhibit.

.A network administrator has begun configuring a Protocol Independent Multicast Sparse Mode (PIM-SM)
solution on all of the network infrastructure devices shown in the exhibit. The administrator has selected the
static method for configuring rendezvous (RPs) and wants to use 4 as RP.
Where must the administrator configure the static RP setting?

Refer to the exhibit.
Exhibit 1

Exhibit 2

Client 1 is transmitting traffic to the data center. Switch 3 transmits the traffic on the link to Switch 1. How does
Switch 1 handle the traffic received from Client 1?

A company has a network with HP Provision switches. The network administrator is establishing remote
mirroring session between two of the switches. The remote does not use the truncation option.
What must the administrator check on any switches between the mirror source and destination?

Refer to the exhibit.
Exhibit 1

Exhibit 2

b
The HP Intelligent Resilient Framework (IRF) virtual devices shown in the Exhibit 1 support traffic for servers in
VLAN 2-10. To enhance resiliency, the network administrator configures MAD on both IRF virtual switches. The
administrator has established the settings shown in the exhibit 2. The configuration has an issue.
How can the administrator correct the issue?

HOTSPOT
Match the HP network infrastructure product to its HP FlexNetwork component.
Hot Area:

Refer to the exhibit.

IRF 3 and Switches 1, 2 and 4 are successfully implementing OSPF on the interfaces shown in the exhibit.
Then IRF 3’s 10.1.10/24 link fails. Connectivity between Server 1 and Server 2 is disrupted for about 30
seconds.
What can the network administrator do to prevent this issue from occurring again?

Refer to the exhibit.

The current software on the Intelligent Resilient Framework (IRF) virtual device shown in the exhibit is version
1104. The network administrator wants to upgrade to software version 1105.
What will happen when the administrator attempts to use In-Service Software Upgrade (ISSU) for this upgrade?