What are two types of supported IPSec VPNs in NSX-T Data Center?
What are two types of supported IPSec VPNs in NSX-T Data Center? (Choose two.) A. policy-based IPSec VPN B. Layer-7 based IPSec VPN C. route-based IPSec VPN D. Open source based IPSec VPN E. SSL based IPSec VPN
Which CLI command should be executed on a KVM hypervisor to retrieve the VM interface UUID?
Which CLI command should be executed on a KVM hypervisor to retrieve the VM interface UUID? A. virsh dumpxml | grep interfaceid B. virsh get-interface C. virsh show | grep interfaceid D. virsh list-interface
Which kernel module on KVM implements a N-VDS?
An NSX administrator has configured a KVM hypervisor as a transport node. Which kernel module on KVM implements a N-VDS? A. openvswitch B. etherswitch C. nsx-vswitch D. dyswitch
What privileges does this user have in the system?
A user is assigned these two roles in NSX Manager: • LB Admin • Network Engineer What privileges does this user have in the system? A. read permissions on all networking services and full access permissions on load balancing features B. full access permissions on all networking services and full access permissions on load balancing […]
What are two supported N-VDS modes?
What are two supported N-VDS modes? (Choose two.) A. DPDK Datapath B. Overlay Datapath C. Secure Datapath D. Enhanced Datapath E. Standard Datapath
Which failover detection protocol must be used to meet this requirement?
An NSX administrator wants to create a Tier-0 Gateway to support equal cost multi-path (ECMP) routing. Which failover detection protocol must be used to meet this requirement? A. Beacon Probing (BP) B. Host Standby Router Protocol (HSRP) C. Bidirectional Forwarding Detection (BFD) D. Virtual Router Redundancy Protocol (VRRP)
Which three steps are required to create an IPsec VPN tunnel?
Which three steps are required to create an IPsec VPN tunnel? (Choose three.) A. Create an IPsec service. B. Add a local endpoint. C. Configure an IPsec session. D. Configure a distributed firewall policy. E. Add a logical switch.
Which command is used to display the network configuration of the Tunnel Endpoint (TEP) IP on a bare metal tra
Which command is used to display the network configuration of the Tunnel Endpoint (TEP) IP on a bare metal transport node? A. ifconfig B. tcpdump C. debug D. ipconfig
Which two choices are prerequisites to configure NSX-T on VDS?
Which two choices are prerequisites to configure NSX-T on VDS? (Choose two.) A. MTU 1500 B. MTU 1400 C. vSphere Distributed Switch 6.5 D. vSphere Distributed Switch 7.0 E. MTU 1600
Which profile allows the administrator to configure the NIC Teaming policy as Failover Order?
An NSX administrator is configuring the KVM hypervisor host as a transport node and wants to apply the Failover Order as a NIC teaming policy. Which profile allows the administrator to configure the NIC Teaming policy as Failover Order? A. N-VDS/VDS Profile B. Transport Node Profile C. Host Switch Profile D. Uplink Profile