— Exhibit –

— Exhibit —
Refer to the Exhibit.
You have an established RSVP LSP from R1 to R4. As shown in the exhibit, you experience a link
failure between R2 and R3.
Which two statements are correct? (Choose two.)

— Exhibit –

— Exhibit —
Refer to the Exhibit.
Referring to the exhibit, your network contains eight devices participating in OSPF Area 0, and
they are all in a full IBGP mesh. R7 is learning the 172.27.0.0/24 network and is injecting this
route into OSPF and BGP. You must ensure that on R2, all traffic destined to the 172.27.0.0/24
network from R1 uses the R2-to-R7 RSVP LSP through your core network.
How should you accomplish this behavior?

— Exhibit –

— Exhibit —
Refer to the Exhibit.
Referring to the exhibit, which two configuration steps must be implemented so that LSPs will be
able to use link protection from R1 to R3? (Choose two.)

— Exhibit –

— Exhibit —

Refer to the Exhibit.
Referring to the exhibit, You have a Layer 3 VPN connecting Site 1, Site 2, and Site 3. Site 1 and
Site 3 have a backdoor IBGP connection. You must meet these requirements:
1. Ensure that PE2 does not advertise the routes learned from PE1 to CE3.
2. Ensure that PE1 does not advertise the routes learned from PE2 that originated from CE3.
3. All routes must be present in Site 2.
Which two statements meet these requirements? (Choose two.)

— Exhibit –

— Exhibit —

Refer to the Exhibit.
Referring to the exhibit, you have recently configured a Layer 3 VPN between Site 1, Site 2, and
Site 3. The CE2 device has all routes from Site 1 and Site 3. The CE3 device has all the routes
from Site 1 and Site 3. CE1 is not receiving any routes from either Site 2 or Site 3.
Which statement is correct?

— Exhibit –

— Exhibit —

Refer to the Exhibit.
Referring to the exhibit, what are three operations performed by the service provider’s PE routers?
(Choose three.)

— Exhibit –

— Exhibit —

Refer to the Exhibit.
Referring to the VPLS network shown in the exhibit, you notice that only one of the two CE sites
configured under the VPLS instance forms a connection to the remote site. The other site remains
in a forwarding and learning mode.
How does PE1 determine which CE within the VPLS instance forms the connection to the remote
site?

— Exhibit –

— Exhibit —
Refer to the Exhibit.
Referring to the exhibit, you see the proper BGP, MPLS, and routing instance configuration for
PE1 and PE2.
Which configuration on PE1 will allow CE1 to communicate with CE2 over a Layer 2 VPN,
assuming PE2 has PPP TCC encapsulation on so-0/0/0.0?