When using the tunnel mpls traffic-eng path-option 1 explicit name test command in Cisco MPLS
TE tunnel configurations, the test explicit-path configuration will consist of a list of which values?

A.
tunnel endpoint

B.
resource class affinity

C.
MPLS label

D.
IP address

Explanation:

tunnel mpls traffic-eng path-option
To configure a path option for a Multiprotocol Label Switching (MPLS) traffic engineering tunnel,
use the tunnel
mpls traffic-eng path-option command in interface configuration mode. To disable the specified
path option,use the no form of this command.
tunnel mpls traffic-eng path-option number {dynamic | explicit {name path-name |
path-number}} [lockdown]
no tunnel mpls traffic-eng path-option number {dynamic | explicit {name path-name
| path-number}} [lockdown]
Syntax Description
number = When multiple path options are configured, lower numbered options are preferred.
dynamic = Path of the LSP is dynamically calculated.
explicit = Path of the LSP is an IP explicit path.
name path-name = Path name of the IP explicit path that the tunnel uses with this option.
path-number = Path number of the IP explicit path that the tunnel uses with this option.
lockdown = (Optional) The LSP cannot be reoptimized.

Usage Guidelines
You can configure multiple path options for a single tunnel. For example, there can be several
explicit pathoptions and a dynamic option for one tunnel. Path setup preference is for lower (not
higher) numbers, so option1 is preferred.
Examples
The following example shows how to configure the tunnel to use a named IP explicit path:
Router(config-if)# tunnel mpls traffic-eng path-option 1 explicit name test