Which two statements best describe the LAG configuration between a Cisco WLC and a Cisco
Catalyst switch? (Choose two.)
A.
The Catalyst switch should be configured for PAgP.
B.
The Catalyst switch should be configured only for Layer 2 load balancing.
C.
The Catalyst switch should be configured for “on” mode.
D.
The Cisco WLC relies on the connected switch to perform the load-balance of traffic.
E.
The Cisco WLC aggregates multiple management interfaces into a single virtual interface.
When LAG is enabled, the system dynamically manages port redundancy and load balances access points transparently to the user.
interface GigabitEthernet
switchport
channel-group mode on
no shutdown
LAG requires the EtherChannel to be configured for ‘mode on’ on both the controller and the Catalyst switch.
0
0