Based on the following partial configuration shown, which statement is true?

Interface FsaEthernet0/1

Switchport access vlan 100

Switchport mode access

Dot1x port-control auto

Dot1x guest-vlan 10

A.
vlan 10, the guest vlan is also known as the restricted vlan

B.
EAP over LAN frames will flow over VLAN 10

C.
client connecting to port fa0/1 with an 802.1x supplicant but fails authentication will be assigned to the vlan 100

D.
client without an 802.1x supplicant connecting to port fa0/1 will be assigned to the vlan 10

E.
client connecting to port fa0/1 with an 802.1x supplicant but fails authentication will be assigned to the vlan 10

Explanation:
Explaination
switchport access
Use the switchport access interface configuration command to configure a port as a static-access port. The port operates as a member of the configured VLAN. Use the no form of this command to reset the access mode to the default VLAN for the switch.
Syntax
switchport access vlan vlan-id
no switchport access vlan vlan-id
Syntax Description
vlan vlan-id
ID of the VLAN. Valid IDs are from 1 to 1005. Do not enter leading zeroes.
switchport mode
Use the switchport mode interface configuration command on the switch stack or on a standalone switch to configure the VLAN membership mode of a port. Use the no form of this command to reset the mode to the appropriate default for the device. switchport mode {access | dot1q-tunnel | dynamic {auto | desirable} | private-vlan | trunk} no switchport mode {access | dot1q-tunnel | dynamic | trunk} Syntax Description

dot1x port-control

Use the dot1x port-control interface configuration command to enable manual control of the authorization state of the port. Use the no form of this command to return to the default setting.
Syntax Description
auto Enable 802.1X authentication on the interface and cause the port to transition to the authorized or unauthorized state based on the 802.1X authentication exchange between the switch and the client.