VSAN traffic is not being routed through SAN fabric. Which action is helpful to resolve the
problem?
A.
Make sure that the FSPF hello interval value matches on both switches.
B.
Change the FSPF hello timer back to the default of 5 seconds.
C.
Make sure that the FSPF hello timers are different so that they do not compete.
D.
Make sure that the FSPF dead timers are both set to 0.
because it says so on the troubleshooting output.
0
0
Resolving a Wrong Hello Interval on an ISL Using Device Manager
To resolve a wrong hello interval on an ISL using Device Manager, follow these steps:
Step 1 Choose FC > Advanced > FSPF and select the Interfaces tab to verify that the FSPF parameters are correct for each interface and check the Hello interval column and the State column.
•The Intervals column shows the configured FSPF timers for this interface, which must match on both sides.
•The State column shows the full or adjacent state if the interface has sent and received all database exchanges and required Acks. The port is now ready to route frames.
Step 2 Repeat Step 1 to determine the value of the hello interval on the adjacent switch.
Step 3 Fill in the Hello field to change the hello interval and click Apply.
0
0
http://www.cisco.com/en/US/products/ps5989/prod_troubleshooting_guide_chapter09186a008067a306.html#wp122779
0
0