Refer to the exhibit.
What commands must be configured on the 2950 switch and the router to allow communication
between host 1 and host 2? (Choose two.)
A.
Router(config)# interface fastethernet 0/0 Router(config-if)# ip address 192.168.1.1
255.255.255.0 Router(config-if)# no shut down
B. Router(config-subif)#encapsulation dot1q 20
Router(config)# interface fastethernet 0/0
Router(config-if)# no shut down
Router(config)# interface fastethernet 0/0.1
Router(config-subif)# encapsulation dot1q 10
Router(config-subif)# ip address 192.168.10.1 255.255.255.0
Router(config)# interface fastethernet 0/0.2
Router(config-subif)# ip address 192.168.20.1 255.255.255.0
C.
Router(config)# router eigrp 100 Router(config-router)# network 192.168.10.0 Router(configrouter)# network 192.168.20.0
D.
Switch1(config)#vlan database Switch1(config-vlan)#vtp domain XYZ Switch1(config-vlan)#vtp
server
E.
Switch1 (config)# interface fastethernet 0/1 Switch1 (config-if)# switchport mode trunk
F.
Switch1 (config)# interface vlan 1 Switch1 (config-if)# ip default-gateway 192.168.1.1