What command can you use to verify the binding table status?

A.
“show ip dhcp snooping binding”

B.
“show ip dhcp pool”

C.
“show ip dhcp source binding”

D.
“show ip dhcp snooping”

E.
“show ip dhcp snooping database”

F.
“show ip dhcp snooping statistics”

Explanation:
Brad
Confidence level: 80%
Note: I researched this question at the following link:
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_58_se/command/
reference/2960cr/cli2.html
If not E is not the correct answer, then the answer is A. However, I’m pretty sure it is E based on these two
quotes:
“Use the show ip dhcp snooping binding command in EXEC mode to display the DHCP snooping binding
database and configuration information for all interfaces on a switch.”
“Use the show ip dhcp snooping database command in EXEC mode to display the status of the DHCP
snooping binding database agent.
BD
@Answer on securitytut.com made a valid comment on the fact that it’s not asking about the database agent,
as Brad’s reference, but on the status (not statistics) of the binding table
On CCNP R&S TShoot 300-135 Official Guide, page 267 it says …
Example 7-26 Verifying DHCP Snooping Bindings
SW1# show ip dhcp snooping binding
MacAddress IpAddress Lease(sec) Type VLAN Interface
—————— ————– ———- ————- —- ————–
08:00:27:5D:06:D6 10.1.1.10 67720 dhcp-snooping 10 FastEthernet0/1
Total number of bindings: 1
So, what is DHCP Snooping bindings and what is the status of binding table? Aren’t they the same. An if so it
clearly says “verify”.